Power feeder for Hammer A3-31 jointer-planer

[Alex Silva]

Hi all,

I'm looking at Steff power feeders and I would like to install one on my
Hammer A3-31. I will also use it on my router table. I'm planning to install my router table near my A3-31 in order to be able to use the power feeder without having to remove it from the A3-31. Is there someone with the same kind of setup ? There are angle brackets that Steff and also Felder are selling in order to be able to tilt the feeder without having to remove it when I want to go into thicknessing mode. I'm not sure what weight the A3-31 will be able to withstand. I don't want the whole thing to tilt !

Thanks

Alex Silva

[John Harden]

You might want to post this at FOG or just call Felder. I'm not sure there is a place on a Hammer to mount the tilt away bracket. Have you looked through the Hammer catalogue to see if there is such an option?

A power feeder and bracket will weigh North of 150 pounds, so I'd be concerned about how to attach it.

Regards,

John