Alex Silva
03-06-2010, 3:43 PM
Hi all,
I'm looking at Steff power feeders and I would like to install one on my
Hammer A3-31. I will also use it on my router table. I'm planning to install my router table near my A3-31 in order to be able to use the power feeder without having to remove it from the A3-31. Is there someone with the same kind of setup ? There are angle brackets that Steff and also Felder are selling in order to be able to tilt the feeder without having to remove it when I want to go into thicknessing mode. I'm not sure what weight the A3-31 will be able to withstand. I don't want the whole thing to tilt !
Thanks
Alex Silva
I'm looking at Steff power feeders and I would like to install one on my
Hammer A3-31. I will also use it on my router table. I'm planning to install my router table near my A3-31 in order to be able to use the power feeder without having to remove it from the A3-31. Is there someone with the same kind of setup ? There are angle brackets that Steff and also Felder are selling in order to be able to tilt the feeder without having to remove it when I want to go into thicknessing mode. I'm not sure what weight the A3-31 will be able to withstand. I don't want the whole thing to tilt !
Thanks
Alex Silva