Brian Runau
02-25-2010, 6:56 PM
My new Grizzly G0586 has a problem on the outfeed table.
Using a straight edge and feeler gauge, I can fit a .003 & .004 under the straight edge on the outfeed table. In feed table is fine.
If I use this the way it is will I ever get decent results from my jointer operation?
I had to take this thing apart to get it into my basement and the crate is gone. I really don't want to take it apart and make another crate so I can return it.
I guess I could take it apart and have a machine shop re-mill the table.
Any suggestions greatly appreciated.
Thanks.
Brian
Using a straight edge and feeler gauge, I can fit a .003 & .004 under the straight edge on the outfeed table. In feed table is fine.
If I use this the way it is will I ever get decent results from my jointer operation?
I had to take this thing apart to get it into my basement and the crate is gone. I really don't want to take it apart and make another crate so I can return it.
I guess I could take it apart and have a machine shop re-mill the table.
Any suggestions greatly appreciated.
Thanks.
Brian