Tony Severenuk (Corel)
02-24-2010, 2:42 PM
As Steve said, there was a lot of work that went into the CorelDRAW X5 Color Management engine. That said, your lasers aren't going to take advantage of it so we wanted to give you guys an easy way out.
Go to Tools>Color Management> Default settings
From the dropdown at the top select "Simulate Color Management Off"
..one extra step here..not really required but you should do it while still in this dialog....the dropdown for "Primary Color Mode"> set it to RGB
Click OK
This will setup the X5 color management engine to work in the same was as X4 if you selected "Color Management Off".
Hope that helps,
T.
Go to Tools>Color Management> Default settings
From the dropdown at the top select "Simulate Color Management Off"
..one extra step here..not really required but you should do it while still in this dialog....the dropdown for "Primary Color Mode"> set it to RGB
Click OK
This will setup the X5 color management engine to work in the same was as X4 if you selected "Color Management Off".
Hope that helps,
T.