kelly logan
02-16-2010, 9:56 PM
I did a search here and did not come up with anything on Tower Leaf blades.
So I thought I should share my findings
I was using a MM16 band saw
I have used tower leaf blades for a while and I put the blade to a test against the Lennox blade. Both are carbide blades
There was no difference in the quality of cut
The blade speed was the same on both blades using a power feeder
Both blades had the same amount of heat after the cuts
The only difference is the Lennox blade was nearly new and the Tower Leaf blade is a used blade
I cut a 12-inch dia. wet red oak 5 ft long
I have attach a pic of both blades
As you can see there is hardly much difference in blades
Go to: www.towerleaf.com (http://www.towerleaf.com) browse the web site, give them a call give these blades a try
The blades are cheaper than the Lennox brand
So I thought I should share my findings
I was using a MM16 band saw
I have used tower leaf blades for a while and I put the blade to a test against the Lennox blade. Both are carbide blades
There was no difference in the quality of cut
The blade speed was the same on both blades using a power feeder
Both blades had the same amount of heat after the cuts
The only difference is the Lennox blade was nearly new and the Tower Leaf blade is a used blade
I cut a 12-inch dia. wet red oak 5 ft long
I have attach a pic of both blades
As you can see there is hardly much difference in blades
Go to: www.towerleaf.com (http://www.towerleaf.com) browse the web site, give them a call give these blades a try
The blades are cheaper than the Lennox brand