New Video: Simple square bowl

[Bob Hamilton]

Hi:
I have uploaded a new series showing the turning of a simple square bowl. It is relatively short compared to my other projects since it is a pretty quick turning and I have edited out all the sanding and finishing steps.

The playlist is available at: http://www.youtube.com/view_play_list?p=4D92FDA120378AA6

Take care
Bob

[Bernie Weishapl]

Really nice video's Bob. Thanks for sharing.

[Ray Bell]

Very nice Bob, I have wanted to try one of these, and now have some idea.

[David E Keller]

Nice video... I love watching your instructional videos, and I greatly appreciate you taking the time to make and post them.

[Chris Hayes]

Bob--
Your videos are always informative and make the topic look easy to do. (But not having patience, it's not that easy for me)

thanks
Chris

[Michael Short]

Great job on the video as always. Thanks for posting.

[Colin MacDiarmid]

good video enjoyed watching

[Rich Aldrich]

Bob,

Really good videos. I am going to start turning soon - lathe is on order - so I am going to watch all of your videos.

[Gary Simmons]

BOB...
Thanks for the video, I have found it and others very helpful. As a turner trying to learn new techniques and ideas, you have certainly helped me move forward...thanks again.

[Derek Stockley]

Bob - thanks for making all these videos. With your videos, you've taught me more about turning than any other single source of information out there! I always look forward to the next one.

[JerHall]

Thanks Bob, Your effort in editing and captions adds a lot of value. This is a keeper.
Jerry

[Mike Stephens]

Again Bob I can not thank you enough.

Your generosity (time & effort) is highly commendable. You are truly a gentlemen and turner for all turners.

Post it and they will learn.

Your loyal fan,
Mike Stephens

[Steve Vaughan]

Thanks for the video. So, I see the video and think, "Hey, I can do that!" Walked into the shop and there was a nice piece of wormy maple...cut the blank today to 7 1/2" square and couldn't resist. Went ahead and mounted it on the lathe...you know, all I was gonna do is put a tool to it and dang if I didn't go ahead and turn the whole bottom! And, now I ain't got time to turn the inside...UGH!

Thanks again for the video and I am finding out that, yes, you can use the lathe and turn things square! Will get a pic as soon as I get this thing finish which will be who knows when.

[Eric Kosanovich]

Thanks Bob liked it so much i just had to make one.
Oak about 9" X 9" i still have some sanding to do.
Great video as you can see.