Dan O'Sullivan
02-11-2010, 7:42 PM
I have a big job to complete with lots of sawn veneer in curly maple and crotch walnut. I have an old Stanley 112 scraper plane and I have a Low angle LN jack. I am undecided on the choice: toothing iron for the scraper or toothing iron for the LA jack??
I am going to be gluing the bandsawn veneer to a hardwood substrate. In the past I have used an old wooden toothing plane with an ancient iron. I would like to upgrade at this point but I am undedided on the scraper or the plane.
Additionally, I am wondering if it will be better to use the finer toothed iron or the broader tooth cut??
I would appreciate any inputs from others who have used newer blades to work this kind of project.
dan
I am going to be gluing the bandsawn veneer to a hardwood substrate. In the past I have used an old wooden toothing plane with an ancient iron. I would like to upgrade at this point but I am undedided on the scraper or the plane.
Additionally, I am wondering if it will be better to use the finer toothed iron or the broader tooth cut??
I would appreciate any inputs from others who have used newer blades to work this kind of project.
dan