Gregg Feldstone
02-10-2010, 9:19 PM
Hi,
I just brought in my DeWalt DW 718, 12" slider for repair.
The entire arm/motor assembly would not stay completely locked in place after the latch plate detent was engaged. The saw has 7 degrees of play in the bevel mechanism.
Also, when attempting to set one of the 45 deg. stops, the bevel adjustment screw actually sheared off part of the threaded housing of the saw table where the screw inserts.
Has anyone else had similar problems with this saw??
I just brought in my DeWalt DW 718, 12" slider for repair.
The entire arm/motor assembly would not stay completely locked in place after the latch plate detent was engaged. The saw has 7 degrees of play in the bevel mechanism.
Also, when attempting to set one of the 45 deg. stops, the bevel adjustment screw actually sheared off part of the threaded housing of the saw table where the screw inserts.
Has anyone else had similar problems with this saw??