Len Levi
02-09-2010, 1:23 AM
Universal X660
Got a new computer and reinstalled the ULS drivers and setup Corel X4.
The table size is 18x32 so aligned the page at 18 vertical.
Problem is when the file is sent to the laser it prints 7" too low
on the vertical. Horizontal is OK.
The origin is set 00 at the top left of the page.
Any thoughts as to why the print comes out 7" too low on the
vertical?
Thanks
Got a new computer and reinstalled the ULS drivers and setup Corel X4.
The table size is 18x32 so aligned the page at 18 vertical.
Problem is when the file is sent to the laser it prints 7" too low
on the vertical. Horizontal is OK.
The origin is set 00 at the top left of the page.
Any thoughts as to why the print comes out 7" too low on the
vertical?
Thanks