richard poitras
02-08-2010, 11:21 PM
Sand Flee Sander Owners
I recently purchased a used 18’’ Sand Flee Sander still in the box that was never used. I have finally assembled it and mounted it on a table ready for use. But there lies the problem to install the sand paper you need to cut a strip of sandpaper to the correct length and angle. Also from what I read you can put two or even three different grits on the drum at once.
What I am looking for is to get a template of the correct length and angle for a single installation and a double and possible a triple if you actually can do a triple on an 18’’ drum. Is there someone out there than I can get a temple from for my needs.( just traced on paper is all I would need) The sander did not come with a instruction manual which I can only assume had a template in it to use for cutting the rolls of sandpaper to the correct length. I don’t want to cut the rolls of sandpaper wrong through trial and air or.
Thanks Richard
I recently purchased a used 18’’ Sand Flee Sander still in the box that was never used. I have finally assembled it and mounted it on a table ready for use. But there lies the problem to install the sand paper you need to cut a strip of sandpaper to the correct length and angle. Also from what I read you can put two or even three different grits on the drum at once.
What I am looking for is to get a template of the correct length and angle for a single installation and a double and possible a triple if you actually can do a triple on an 18’’ drum. Is there someone out there than I can get a temple from for my needs.( just traced on paper is all I would need) The sander did not come with a instruction manual which I can only assume had a template in it to use for cutting the rolls of sandpaper to the correct length. I don’t want to cut the rolls of sandpaper wrong through trial and air or.
Thanks Richard