View Full Version : crown molding cutter
Mark J Bachler
02-08-2010, 8:38 AM
I'm looking for a vert. 2 1/4" crown molding cutter for my 1 1/4" bore shaper. Any ideas??
Rod Sheridan
02-08-2010, 9:54 AM
Perhaps an insert tool head such as this one from FS Tools?
Regards, Rod.
http://www.fstoolcorp.com/Templates/ecms.aspx/$FSTool/9623519e-2e8b-4300-8c01-9f2581a22828/C10_C11.pdf
Paul B. Cresti
02-08-2010, 9:54 AM
Hey Mark,
I have a corragated head from CG Schimdt, with plenty of knives.... IF it is a simple one off quick job you might what to consider Grizzly
Paul
Quinn McCarthy
02-08-2010, 10:30 AM
I have the Grizzly cutter. I just never found a consistant way to run it. I set up my power feed which helped a bit. I ended up just buying a W&H moulder which does a great job.
Quinn
David DeCristoforo
02-08-2010, 1:49 PM
In my experience, running crown on a shaper is a PITA. It can be done but if you are going to be running a lot of crown on a fairly regular basis, you might want to consider investing in a small moulder like the W&H so you can run the crown flat.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.