Michael Simpson Virgina
02-04-2010, 2:25 AM
I received and installed my mini air compressor from Epilog.
My first impressions are very positive. Its a very efficiant and quite little compressor. Its much smaller than the beasts I have been using and and quieter than many of the airbrush compressors I have tried.
You have to make sure you have the rear solenoid on the mini set to let air pass when the laser is off or the compressor will not start. Just remove the screws on the solenoid and reverse the hoses. If you are using a tanked compressor you want just the opposite.
I have a regulator and filter at the laser and get about 40+PSI at the laser. I normally run it at 10-15psi.
It works just as good as my tanked compressor but takes up zero space behind the laser.
My first impressions are very positive. Its a very efficiant and quite little compressor. Its much smaller than the beasts I have been using and and quieter than many of the airbrush compressors I have tried.
You have to make sure you have the rear solenoid on the mini set to let air pass when the laser is off or the compressor will not start. Just remove the screws on the solenoid and reverse the hoses. If you are using a tanked compressor you want just the opposite.
I have a regulator and filter at the laser and get about 40+PSI at the laser. I normally run it at 10-15psi.
It works just as good as my tanked compressor but takes up zero space behind the laser.