View Full Version : mesquite saw mills in TX?
Gene Howe
02-01-2010, 7:02 PM
We will be headed from Port Aransas Texas on 35 to San Antonio then on to the 10 west to AZ. Anybody know where I might buy some mesquite lumber along the way?
thanks guys.
Gene
Michael Schapansky
02-01-2010, 7:16 PM
http://www.texaskilnproducts.com
This isn't right on your way, it's about 75 miles northeast of San Antonio, just east of Bastrop TX. I haven't been there yet but it's on my list to go to when I want some milled mesquite. They sell some finished goods, and rough lumber also.
Scott T Smith
02-01-2010, 10:11 PM
Gene, give these folks a call:
http://www.texmes.com/default.asp
They are furniture crafters that specilize in mesquite. If they don't have some lumber to sell you, they should be able to steer you to a supplier.
It's worth the trip just to see some of their furniture - it is spectacular.
They are in Bertram, TX, about 30 miles or so west of I-35/Georgetown.
Tom Winship
02-01-2010, 11:25 PM
http://www.texaskilnproducts.com
This isn't right on your way, it's about 75 miles northeast of San Antonio, just east of Bastrop TX. I haven't been there yet but it's on my list to go to when I want some milled mesquite. They sell some finished goods, and rough lumber also.
Gene, +1 on Texas Kiln Products. Go out of your way, but go. I have bought about 200 board ft of mesquite in the last year from them. 2 brothers, Ray and Bo Shelton. The mill is off the highway, they have an outlet store on the highway. Call them before you go. Tell them I sent you. They will treat you right.
Tom Winship
Terry Crump
02-02-2010, 11:39 AM
Give these guys a call.
http://www.texasmesquiteassn.org/default.htm
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.