dennis thompson
01-23-2010, 1:38 PM
I am building a computer desk. The top & bottom are 23/32" plywood. There are two dividers (23/32" thick) between the top & bottom which fit into 1/4" dadoes I have cut. The instructions (the plan is from Woodsmith) call for gluing the dividers into the dadoes, My questions are:
-should I use pocket screws in addition to the glue(the dividers will be inside the desk so the pockets screws won't be seen)?
-if pocket screws are recommended what size should I use...the dividers are 23/32" & they fit into a 1/4" dado so the wood the screws would go thru (the dividers) is 23/32 & the screws would go into wood about 15/32" thick?
Thanks
Dennis
-should I use pocket screws in addition to the glue(the dividers will be inside the desk so the pockets screws won't be seen)?
-if pocket screws are recommended what size should I use...the dividers are 23/32" & they fit into a 1/4" dado so the wood the screws would go thru (the dividers) is 23/32 & the screws would go into wood about 15/32" thick?
Thanks
Dennis