Ian Wilson (AUST)
01-18-2010, 8:35 PM
Hello Creekers,
Can someone please help with this file. I had original Uni Degree template but now some of the signatures have changed, I tried to cut/ crop/ delete signatures with no luck, I'm using X4. So I placed a white square over the top, then placed the new signatures on top, looked good to go. Now when i go to engrave I get a "Shadow" of the white square on the timber.
Can someone please delete all inside the small red box ( bottom left side of plaque) of the attached file and advise how I could delete that section.
Any help would be appreciated.
Regards, Ian
Can someone please help with this file. I had original Uni Degree template but now some of the signatures have changed, I tried to cut/ crop/ delete signatures with no luck, I'm using X4. So I placed a white square over the top, then placed the new signatures on top, looked good to go. Now when i go to engrave I get a "Shadow" of the white square on the timber.
Can someone please delete all inside the small red box ( bottom left side of plaque) of the attached file and advise how I could delete that section.
Any help would be appreciated.
Regards, Ian