Help with file

[Ian Wilson (AUST)]

Hello Creekers,


Can someone please help with this file. I had original Uni Degree template but now some of the signatures have changed, I tried to cut/ crop/ delete signatures with no luck, I'm using X4. So I placed a white square over the top, then placed the new signatures on top, looked good to go. Now when i go to engrave I get a "Shadow" of the white square on the timber.

Can someone please delete all inside the small red box ( bottom left side of plaque) of the attached file and advise how I could delete that section.

Any help would be appreciated.

Regards, Ian

[Guy Hilliard]

Ian;

The red area and the titles associated with the signatures are a bitmap embedded in the graphic. To remove it you just left click on it and hit delete (in X4 anyway). You will need to create a new signature block with titles.

[Ian Wilson (AUST)]

Hi Gil,


Thats the top or new signature box...........underneath that is a white box and under that is the old signatures. Attached is the original , can you pls delete the Titles and signatures?

Thanks you.

Ian

[Dave Russell Smith]

Is this what you are after.

[Ian Wilson (AUST)]

Thanks .......it now looks fantastic!!!!

Much appreciate.

Ian