View Full Version : Help with file

Ian Wilson (AUST)
01-18-2010, 8:35 PM
Hello Creekers,

Can someone please help with this file. I had original Uni Degree template but now some of the signatures have changed, I tried to cut/ crop/ delete signatures with no luck, I'm using X4. So I placed a white square over the top, then placed the new signatures on top, looked good to go. Now when i go to engrave I get a "Shadow" of the white square on the timber.

Can someone please delete all inside the small red box ( bottom left side of plaque) of the attached file and advise how I could delete that section.

Any help would be appreciated.

Regards, Ian

Guy Hilliard
01-18-2010, 9:03 PM

The red area and the titles associated with the signatures are a bitmap embedded in the graphic. To remove it you just left click on it and hit delete (in X4 anyway). You will need to create a new signature block with titles.

Ian Wilson (AUST)
01-18-2010, 11:02 PM
Hi Gil,

Thats the top or new signature box...........underneath that is a white box and under that is the old signatures. Attached is the original , can you pls delete the Titles and signatures?

Thanks you.


Dave Russell Smith
01-18-2010, 11:30 PM
Is this what you are after.

Ian Wilson (AUST)
01-20-2010, 7:39 AM
Thanks .......it now looks fantastic!!!!

Much appreciate.