Cameron Reddy
01-14-2010, 3:34 PM
I'm putting this on my PM2700 shaper and I want to make sure it is powerful enough and has enough reach. I can't get a good enough resolution picture of the brochure on the Steff 2033 power feeder to make out how much horizontal reach it has.
I'm attracted to it because it has 8 speeds, starting at a very slow 9 fpm. It's only .6 hp, however.
I can get it for $850 delivered.
If I could get the Powermatic PF 31 for that price I'd take it, because I know that it has enough horizontal reach (18"). Plus it is pretty gold.
Comments?
I'm attracted to it because it has 8 speeds, starting at a very slow 9 fpm. It's only .6 hp, however.
I can get it for $850 delivered.
If I could get the Powermatic PF 31 for that price I'd take it, because I know that it has enough horizontal reach (18"). Plus it is pretty gold.
Comments?