Delta unisaw extension wing question

[JOSHUA PRUITT]

I have a delta unisaw and when I got it there was already an extension table on one side. I did get the other extension wing with it and wanted to know if there were any problems with putting two extension wings on the same side? If I have it I figure I might as well use it! Any info would be great, Thanks!

[Ray Newman]

The extension mounted to the saw will eventually sag if you add an extra extension.

[Bruce Page]

The weak link is where the first wing attaches to the saw top. The connection could fail if you put too much weight out at the edge of that cantilever.
I have an extra wing that came off of my Unisaw too, but I wouldn’t do it.

[Van Huskey]

Just support the new wing with either 2 or better yet 4 legs, then sag is a non-issue.

[Jerome Hanby]

Of if you feel like cutting on it, might make a killer router table top...

[JOSHUA PRUITT]

I can see where the lag would come in! Thank you for your quick answers.