View Full Version : Delta unisaw extension wing question
JOSHUA PRUITT
01-11-2010, 11:32 AM
I have a delta unisaw and when I got it there was already an extension table on one side. I did get the other extension wing with it and wanted to know if there were any problems with putting two extension wings on the same side? If I have it I figure I might as well use it! Any info would be great, Thanks!
Ray Newman
01-11-2010, 12:03 PM
The extension mounted to the saw will eventually sag if you add an extra extension.
Bruce Page
01-11-2010, 12:15 PM
The weak link is where the first wing attaches to the saw top. The connection could fail if you put too much weight out at the edge of that cantilever.
I have an extra wing that came off of my Unisaw too, but I wouldn’t do it.
Van Huskey
01-11-2010, 12:26 PM
Just support the new wing with either 2 or better yet 4 legs, then sag is a non-issue.
Jerome Hanby
01-11-2010, 12:39 PM
Of if you feel like cutting on it, might make a killer router table top...
JOSHUA PRUITT
01-11-2010, 1:23 PM
I can see where the lag would come in! Thank you for your quick answers.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.