brian c miller
01-07-2010, 6:50 PM
Can you trust the router lift scale?.
Can you count on the fact that you move the thumb wheel down .016 and the bit moves down .016? According to my height gauge it seem to "jump" .009 but will return to zero.
I would like to be able to take a test cut, measure, and make one offset. Seems to be accurate going down then up.
Is this normal movment down?
http://www.youtube.com/watch?v=hozhbjxqHnA
Can you count on the fact that you move the thumb wheel down .016 and the bit moves down .016? According to my height gauge it seem to "jump" .009 but will return to zero.
I would like to be able to take a test cut, measure, and make one offset. Seems to be accurate going down then up.
Is this normal movment down?
http://www.youtube.com/watch?v=hozhbjxqHnA