View Full Version : Delta 46-460 VS question?
Alan Tolchinsky
01-06-2010, 10:25 PM
Hi,
Can somebody please measure the spindle height of this lathe from the base? I need to have this to make a stand and don't have the lathe yet. I thought I read it was 12.5". Is this correct? Thank you.
Jeff Nicol
01-06-2010, 10:29 PM
Hi,
Can somebody please measure the spindle height of this lathe from the base? I need to have this to make a stand and don't have the lathe yet. I thought I read it was 12.5". Is this correct? Thank you.
Alan, It is 14.5" from the base to the center of the spindle.
Jeff
Alan Tolchinsky
01-07-2010, 10:24 AM
I'll revise my plans by 2". Alan
Joe Aliperti
01-07-2010, 1:08 PM
Post pics of the stand once it's done!
Jack Gaskins
01-07-2010, 6:09 PM
Yes, please throw up some photos once your done. I have a 460 coming in the mail as well but I have a massive 300 pound bench I was going to bolt mine to until I could come up with a "slimmer" stand set-up.
Alan Tolchinsky
01-07-2010, 7:23 PM
Sure no problem!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.