No vibration

[Rob Bourgeois]

This is the joy of a well tuned Gold standard.

Powermatic 14 inch bandsaw running with a stock belt, and a nice secure mobile base. I figured the picture guys would like this one.

[Dick Parr]

Very nice, but I bet that saw will slice them thinner then that. :D :D

[Jim Becker]

Very kewel. Do tell us about your little air attachmet to blow dust. Your own? Commercial? Etc.

[Lee Schierer]

So how do you get the super glue off your table that is holding those coins in position?? Just kidding ..

[Tyler Howell]

So how do you get the super glue off your table that is holding those coins in position?? Just kidding ..

ROTFLOL Good one Lee.
I would expect nothing less of the Gold Standard.:cool:

[Rob Bourgeois]

The air attachment comes standard. It hooks to the back of the motor. Only down side to it is you have to adjust it to get it to blow right where you need it as you change wood thickness...but that is unavoidable. Works good for seeing the line on curves. There is also a light attached to it that is also standard.

Heres a link to check it out
http://www.wmhtoolgroup.com/index.cfm?area=shop&action=detail&iid=12755

The only thing I added is a mobile base(HTC). I am getting some better blades for it this week(I hope) to really test if I can cut thin slices with it.

[Rob Bourgeois]

Lee..acetone... :p

[Chris Padilla]

You really should turn the saw ON, Rob.... It just looks like filed down hacksaw blade in the guides there.... ;)

[Steve Clardy]

Looks nice and NEW!! Will it do a half dollar?
Steve

[Anthony Yakonick]

I just tried this with my 16" Reliant saw, I can stand a nickel on it with no problem, The vibration causes the nickel to roll off not fall over :confused: :rolleyes:

[John Miliunas]

OK Rob, I'm pretty impressed, but where's the DIME?! :D :cool:

[Rob Bourgeois]

I didnt have one in my pocket or the shop. :)

[John Miliunas]

Ahhh...Good excuse! I, on the other hand, can't balance a dime on end, regardless of what I place it on! :rolleyes: :cool:

[Rob Bourgeois]

John
I found out I can't either. Either that are my computer desk, kitchen cabinets and dining room table all have too much vibration. This is great now I am going to spend the whole morning trying to get a dime to stand on end. Thanks :rolleyes: