Frank Ricci
12-30-2009, 3:56 PM
Hello everyone
Well I purchased a 2004 10 watt Xenetech 1325 and I can't communicate to the machine. I did change the port settings in the software program 6.30, I have Com1 as the port. What is a JobServer? I downloaded every patch I could find on the Xenetech web site and the new print driver.
I would just like to use the 9 pin serial port direct from my CPU. There is an option to turn off the Ethernet on the machine control. I hoped it would act just like a printer and dump the program to the laser just like a ULS laser. The print driver shows all the lasers option for power speed ect.
Frank
chewbarka.com
Well I purchased a 2004 10 watt Xenetech 1325 and I can't communicate to the machine. I did change the port settings in the software program 6.30, I have Com1 as the port. What is a JobServer? I downloaded every patch I could find on the Xenetech web site and the new print driver.
I would just like to use the 9 pin serial port direct from my CPU. There is an option to turn off the Ethernet on the machine control. I hoped it would act just like a printer and dump the program to the laser just like a ULS laser. The print driver shows all the lasers option for power speed ect.
Frank
chewbarka.com