Dave Clermont
12-29-2009, 10:57 PM
LOML got me the G0604X as a surprise Christmas gift this year woohoo. It came in last week, first chance I had had to set it up was today. Everything went pretty smooth, all though I do seem to be running into an issue and wonder if someone could help me out.
When I installed the fence carriage I followed the instructions and placed a piece of paper under the carriage before I tightened it down. Then I attached the fence and all seemed to go ok, the fence was not making contact with either table. When I was aligning the jointer I noticed that the fence carriage would stop before sliding over the tables the left corner of the fence carriage (right near the stop bolt) was contacting the table and stopping it from moving forward any further...
So did I do something incorrect during the fence carriage or fence install or is it suppose to stop at that point? If not who do I correct it?
Thanks!
When I installed the fence carriage I followed the instructions and placed a piece of paper under the carriage before I tightened it down. Then I attached the fence and all seemed to go ok, the fence was not making contact with either table. When I was aligning the jointer I noticed that the fence carriage would stop before sliding over the tables the left corner of the fence carriage (right near the stop bolt) was contacting the table and stopping it from moving forward any further...
So did I do something incorrect during the fence carriage or fence install or is it suppose to stop at that point? If not who do I correct it?
Thanks!