Rob Sandall
12-19-2009, 10:14 AM
Hi folks. I hoped I would never have to beg for help out here, but my table on my V460 wont go "up" anymore. It started sporadically refusing to raise, and a off/on cycle of the laser would fix it. This was last night. This morning it won't go up at all, and a z-axis re-home has it stuck at the bottom.
Gulp!
I have a ton of orders to ship Monday for Christmas. Any ideas out there?
I cleaned all the sensors, made sure there was no debris in any belts, tried manually pushing upwards to "help" it. For a while it would travel up to one specific height, then stop. Back down, back up - then stop at the same point. Other times it would only travel down.
For a short while, right before final death, it would travel up then when I let go of the button it would continue upwards at lower speed for a couple seconds. Weird.
Well - for now I am stacking various thicknesses of boards under the cutting table to get as close to focus as I can.
Thanks for any advice!
-Rob
Gulp!
I have a ton of orders to ship Monday for Christmas. Any ideas out there?
I cleaned all the sensors, made sure there was no debris in any belts, tried manually pushing upwards to "help" it. For a while it would travel up to one specific height, then stop. Back down, back up - then stop at the same point. Other times it would only travel down.
For a short while, right before final death, it would travel up then when I let go of the button it would continue upwards at lower speed for a couple seconds. Weird.
Well - for now I am stacking various thicknesses of boards under the cutting table to get as close to focus as I can.
Thanks for any advice!
-Rob