View Full Version : HELP! Unknown Fence Part???
Chip Lindley
12-17-2009, 4:43 PM
Pix below of an aluminum extrusion I received in a drawer-full of goodies. I've searched every maker of router fences, etc. I can think of (Incra, Kreg, Woodpeck, etc.etc.) To no avail.
The piece is 24" long, 3" tall. I sure wish I had another one just like it to make a split router fence on my PM66 extension table. Any ideas? Thanks All!
Josiah Bartlett
12-17-2009, 4:45 PM
It could be for a Bandsaw.
Jeremy Tomlinson
12-17-2009, 6:05 PM
Fastrak - they made bandsaw fences and sharpening/grinding guides. Looks like their cross section
Mike Langford
12-17-2009, 7:17 PM
Chip, That is just a worthless piece of scrap....Send it to me and I'll dispose of it for you....:D....I'll email you my mailing address.....
.
.
.
.
.
....I vote bandsaw fence!
.
.
.
.
Peter Quinn
12-17-2009, 7:49 PM
Check out the 80/20 aluminum extrusion site, they may have a match. Possibly the 3034-lite profile?
http://download.8020inc.net/PDF/Fractional_Section_1.pdf
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.