Brian Runau
12-17-2009, 8:39 AM
I just got a new G0586, but had to take the in/out feed tables off to get it into the basement. Outfeed table is fine, but the infeed table has a lot of play up and down. If I lift the end away form the cutterhead it levels across the cutter head with my precision straight edge.
Gibs are installed at the bottom of the ways.
Any ideas on how to adjust this out so the in feed table is on the same plane as the outfeed table?
Would adjusting the gib screw nuts push the end of infeed table up that much?
I e-mailed the tech guys and Grizzly and I am waiting to hear.
Thanks for any and all.
Brian
Gibs are installed at the bottom of the ways.
Any ideas on how to adjust this out so the in feed table is on the same plane as the outfeed table?
Would adjusting the gib screw nuts push the end of infeed table up that much?
I e-mailed the tech guys and Grizzly and I am waiting to hear.
Thanks for any and all.
Brian