View Full Version : Kreg Router Fence on a Different Table Top?
Bill Franklin
12-14-2009, 5:34 PM
Has anyone mounted their Kreg router table fence on a different product? If so, who's tabletop did you use? Any pointers on where you picked up the hardware you needed?
I am not sure I need to do this yet, but it seems like a viable project.
Thanks in advance,
Bill
Chuck Isaacson
12-15-2009, 6:56 PM
I built my own table and mounted it to it. It worked out very nicely. It really is a great fence. I did try to do a little bit of edge jointing with it and didn't have much luck. I was just messing around trying it. Everything else is nice. I didn't need any special hardware. I am pretty sure that I just used everything that came with it. Here are some pics.
http://www.sawmillcreek.org/showthread.php?t=119596
If you have anymore questions or need more pics,, let me know.
Chuck
Phil Harding
12-15-2009, 7:30 PM
My Incra router table top (I built my own base) does double duty as my table saw outfeed table. I mounted the Kreg fence on this table. The installation was very straight forward. I did route a slot on the right side of the table top so the back side of the fence can be locked down. I like this fence setup because it easily and quickly comes off when I need to use the table as the tablesaw outfeed. Putting it back on is just as easy.
-- Phil
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.