Philip Florio
12-10-2009, 8:28 PM
I'm trying to find an easy an quick way to add a 2 part epoxy in a Cutlery handle.
I was trying to find a glue syringe in hobby shops but all I could find were small squeeze bottles that weren't very successful. The hole is 1/4" diameter and about 1 1/4" in depth. Part of the problem is the thickness of the epoxy plus the air that gets trap.
I'm wondering if I could use a plastic tube hooked up to a compressor to some how get the epoxy in the hole.
Any thoughts?
Phil
I was trying to find a glue syringe in hobby shops but all I could find were small squeeze bottles that weren't very successful. The hole is 1/4" diameter and about 1 1/4" in depth. Part of the problem is the thickness of the epoxy plus the air that gets trap.
I'm wondering if I could use a plastic tube hooked up to a compressor to some how get the epoxy in the hole.
Any thoughts?
Phil