Kyle Tucker
11-24-2009, 1:51 AM
Hello,
I have the Craftsman zip code table saw, and today found the need for a 45 degree zero clearance insert. The problem is that when the blade is angled to 45 degrees, it does not sit below the opening for a insert (the insert will not sit flush in the opening to raise the blade into it and make the new zero clearance plate). Hopefully my explaination makes sense, but do any of you have any ideas on how I may be able to pull this off?
I have the Craftsman zip code table saw, and today found the need for a 45 degree zero clearance insert. The problem is that when the blade is angled to 45 degrees, it does not sit below the opening for a insert (the insert will not sit flush in the opening to raise the blade into it and make the new zero clearance plate). Hopefully my explaination makes sense, but do any of you have any ideas on how I may be able to pull this off?