dennis thompson
11-23-2009, 7:03 AM
I'm building a cabinet which will have cockmoldoing inside the door that is 3/16" thick by 3/4" wide, what size pin/nail should I use to go thru the 3/16" to insure I don't split it? or can I just glue it?
I also have to do a raised panel for the first time. I'm plan to do it on the table saw. I know I need to attached a taller board to my fence to insure stability but I'm wondering if I need to do anything else, any suggestions will be appreciated. The raised panel door is 8 1/2" x 12 1/2"
Thanks
Dennis
I also have to do a raised panel for the first time. I'm plan to do it on the table saw. I know I need to attached a taller board to my fence to insure stability but I'm wondering if I need to do anything else, any suggestions will be appreciated. The raised panel door is 8 1/2" x 12 1/2"
Thanks
Dennis