James Sears
10-28-2009, 12:01 PM
I have a nice old jounter - 1940's or earlier, made in england. No makers name, just a brass plate saying to buy lubricants from a London company.
Problem - it has a 6¼" , 2 knife cutter and there are 2 pins that matching notches on the edge of the blades drop onto. It looks like no alignment, no height adjustment of the blade, just clamp them in and adjust the outfeed table to match. The blades are 1/8 thick. Has anyone seen this before and have any idea where I could find replacements?
Next choice is to remove the pins and use regular blades.
Jim Sears
Problem - it has a 6¼" , 2 knife cutter and there are 2 pins that matching notches on the edge of the blades drop onto. It looks like no alignment, no height adjustment of the blade, just clamp them in and adjust the outfeed table to match. The blades are 1/8 thick. Has anyone seen this before and have any idea where I could find replacements?
Next choice is to remove the pins and use regular blades.
Jim Sears