Dewalt 735 adjustment?

[Byron Trantham]

Has anyone adjusted the thickness setting (fixed stops) on the 735? Mine is a bit proud. I would like to adjust it to a more accurate setting. I see the post that acts as a stop for each detent but I am a little unsure if this is the place to adjust it. Any help will be greatly appreciated. BTW there is no reference to this in the manual. :mad:

[JohnT Fitzgerald]

Byron - I do not use the fixed stops on mine. I installed a Wixey thickness gauge and use that for the 'final say'. it's easy to calibrate, and dead-on.

[Jeff Monson]

You are correct, the post for the detents has a locknut on the bottom, just loosen the locknut and screw in the post until you get back to the correct setting.

[Myk Rian]

After putting the Byrd Shelix on mine it is out of adjustment. I use a Wixey gauge so I haven't bothered with it.
One of these days I'll get it adjusted.