Duane Parcells
10-21-2009, 7:21 PM
Played a little more with eggs on the rotary attachment. A candle makes a fine holder. Hollow out the end a little, melt a drop of wax on each end of the egg, soften the ends of the candle and attach. Don't move too soon, it takes a few minutes to fully re-harden. Had to play with power settings for a while to get it right. My laser is 75 watts. The oval was cut at 20 speed, 30 power and 500 freq. The other stuff you see are failed settings of intricate designs. Remove the candle with a hot knife or soldering iron. That last picture had to be done because.
I have to move on to other things for a while. Hope someone can run with this. One last note, Lasering a egg really stinks!
I have to move on to other things for a while. Hope someone can run with this. One last note, Lasering a egg really stinks!