The dry fit

[Mike Heidrick]

Needed a quick queen size headboard for a steel frame bed. Still have sanding to do and finishing and making some end caps for the bedposts.

http://i39.photobucket.com/albums/e169/BloomingtonMike/hb1.jpg

http://i39.photobucket.com/albums/e169/BloomingtonMike/hb2.jpg

Here Megan is helping clean out the mortises for me (psi is WAYYY down BTW on the compressor). It's her new headboard. She is moving to the big girl room in a couple weeks and the new baby girl coming in Novemeber gets the baby room.

http://i39.photobucket.com/albums/e169/BloomingtonMike/Meganmortise.jpg

[John Keeton]

Mike, the headboard is a really clean and simple design that works! Some nice looking oak there, too.

You didn't ask, but have you considered a cap along the top of the paneled section? Perhaps just about 3/8" shy of the post width. It may add a bit of interest and a finishing touch along with the post caps. Just a thought.

Also, your shop assistant is first rate! She is a cutie, and obviously a big help. I admire your efforts in involving her - hopefully, she will carry on Dad's talented woodworking hobby.

[John Thompson]

Nice and clean as JK mentions.. nice job on the panels. Looking at a picture posted doesn't always equal clarity and you probably already have done this but.. be sure to soften the edges on the post ever so slightly. As I say it is not clear and you probably already have done so.

Seeing Megan beside that post it just came to mind as my BIL who is a hydraulics foreman at Delta got into WW a year or so ago. He also built a bed but did not soften the corners. Resulted in a pretty good paper cut on his young daughters hand.

Again.. nice job!

[Mike Heidrick]

I cut out bedpost capitals with 11 degree pyramids Jeff Miller showed in his book Beds. Here they are resting on the headboard. I may add a similar base to each post as well. I am also going to round these over once I set up the router table or shaper to do it for everything. Also shown is my version of his jig.

http://i39.photobucket.com/albums/e169/BloomingtonMike/capitals1.jpg

http://i39.photobucket.com/albums/e169/BloomingtonMike/capitals2.jpg

http://i39.photobucket.com/albums/e169/BloomingtonMike/capital4.jpg

http://i39.photobucket.com/albums/e169/BloomingtonMike/capital3.jpg

http://i39.photobucket.com/albums/e169/BloomingtonMike/pyramidjig.jpg

[Matt Meiser]

I like it Mike. Its similar to one I want to build for LOML and I, but ours will have an arched top.

[John Thompson]

Those top caps add greatly to your over-all look there Mike. A base migth also add some pi-zazz as you mentioned which would add some balance. Nice job on this thing..

[Keith Christopher]

I really like this headboard ! Great job.

And enjoy that lil helper ! In about 12 years she won't want to step foot in a shop. (I miss my lil helper! :) )

[Kevin Looker]

Very nice work. Especially if this is just a "quick" headboard.

How did you raise the panels? With router table or some other means?

Also, do I see both a hollow chisel mortiser & a slot mortiser in your shop?

Kevin Loker