Daniel Shnitka
09-07-2009, 1:53 PM
I am needung help to find a supplier of washer used in the cabinet industry:
Diameter approximately half an inch
Depth: approximately three sixteenth ( straight sided)
Centre hole of washer: approximately one eigth inch
What The is critical about these washer is the sloped shoulder from out side edge sloping down to the centre hole ( much like an extinct volcano).
If any of you have a source or a handfull I need them for a special cabinet job. I'll happily cover any expenses you have.
Diameter approximately half an inch
Depth: approximately three sixteenth ( straight sided)
Centre hole of washer: approximately one eigth inch
What The is critical about these washer is the sloped shoulder from out side edge sloping down to the centre hole ( much like an extinct volcano).
If any of you have a source or a handfull I need them for a special cabinet job. I'll happily cover any expenses you have.