View Full Version : Sizing Power Twist Plus
Scott Hildenbrand
09-06-2009, 5:19 PM
What's the most common width to use for power tools? I see alot of 1/2" and 3/8ths.. Assuming 3/4 is WAY too big for anything then?
glenn bradley
09-06-2009, 5:25 PM
My old contractor saw, current jointer, band saws and drill presses are all 1/2".
Dell Littlefield
09-06-2009, 7:08 PM
I used 1/2 inch on my table saw and band saw but had trouble on my planer because the belt rode too high on the pulleys and dragged on the shield. This also requires a little longer belt because it rides so high.
http://www.sawmillcreek.org/showthread.php?t=119712
Scott Hildenbrand
09-06-2009, 7:32 PM
Alright.. I had a chance to get 25' of 3/4 DIRT cheap, but since it'll be useless to me, no point.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.