View Full Version : Fluid Flim??
Jerry Balzell
09-04-2009, 9:43 PM
I may have to put my tools in lay up for about 12 mos. I have done allot of research on this site as well as on line. Has anyone tried Fluid Flim? The item description states "it will leave a thin wet film". That sounds like an advantage. I was thinking of putting plastic wrap over the top of the Fluid Flim.
Link http://www.theruststore.com/Fluid-Film-C67.aspx
Thanks for your input.
Jerry
Gary Herrmann
09-04-2009, 11:49 PM
I use it on my tools. There was an article several years ago that rated it the best for rust prevention.
Jerry Bruette
09-05-2009, 7:38 AM
Jerry
We use a product called Lectra Shield at work, it's sorta like cosmoline in a spray can, only it cleans off easier. It's made by CRC and available on amazon. CRC used to make a product called SP-400 not sure if it's still available but it was good too.
Good Luck
Jerry
Craig T. Smith
09-05-2009, 7:38 AM
Jerry, I work heavy construction, We use it all the time . From storeing new metal to new parts we're not going to use right away. GREAT-STUFF. As long as the tools were'nt in direct contact with water I don't think plastic would be needed or advised . It will protect a long time . Good luck, Craig
Jerry Balzell
09-05-2009, 7:50 AM
Thanks for the input.
Jerry:)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.