Paul Dell'Anno
09-04-2009, 7:10 PM
I have a Bench Dog Router table which the phenolic top (It was purchased new 2 years ago). After struggling with bit changes and height adjustments, I bit the bullet and purchased the new PRL V2 from Woodpecker (they just came out with a lift for the Bench Dog tops). Well, my streak of good luck continues. When I went to install the lift, it doesn't fit!!! The thumb wheel on the new lift makes contact with the lip which supports the router plate. I could notch out the lip, but I am afraid that there would not be enough material left to support the PRL plate. Has anyone else run into an issue like this? Thanks in advance for the help.