Kevin Groenke
08-25-2009, 9:35 PM
I just discovered that the Kreg Klamp works perfectly as a drill press clamp. I imagine it could be used an any drill press, but it works especially well on one with T slots. I did flatten the sides of a washer to distribute the load on the T slot a bit more. The included Kreg bolt and the washer simply slide into either T slot, the 6" reach makes it to the center of the table. I previously tried the Festool ratchet clamp, it fit in the slot, but since it didn't rotate like the Kreg, it didn't really work very well.
http://lh3.ggpht.com/_WhsyjpgLrx4/SpSNu5kL3vI/AAAAAAAAAbA/Hl32OyQqHvM/s640/P8240001.JPG
http://lh3.ggpht.com/_WhsyjpgLrx4/SpSNv063JuI/AAAAAAAAAbE/RVxeUgVpcOw/s640/P8240004.JPG
http://lh3.ggpht.com/_WhsyjpgLrx4/SpSNw8SnpSI/AAAAAAAAAbI/qC9Z2kHc_d0/s640/P8240008.JPG
http://lh3.ggpht.com/_WhsyjpgLrx4/SpSNu5kL3vI/AAAAAAAAAbA/Hl32OyQqHvM/s640/P8240001.JPG
http://lh3.ggpht.com/_WhsyjpgLrx4/SpSNv063JuI/AAAAAAAAAbE/RVxeUgVpcOw/s640/P8240004.JPG
http://lh3.ggpht.com/_WhsyjpgLrx4/SpSNw8SnpSI/AAAAAAAAAbI/qC9Z2kHc_d0/s640/P8240008.JPG