Kreg Klamp great on drill press

[Kevin Groenke]

I just discovered that the Kreg Klamp works perfectly as a drill press clamp. I imagine it could be used an any drill press, but it works especially well on one with T slots. I did flatten the sides of a washer to distribute the load on the T slot a bit more. The included Kreg bolt and the washer simply slide into either T slot, the 6" reach makes it to the center of the table. I previously tried the Festool ratchet clamp, it fit in the slot, but since it didn't rotate like the Kreg, it didn't really work very well.

http://lh3.ggpht.com/_WhsyjpgLrx4/SpSNu5kL3vI/AAAAAAAAAbA/Hl32OyQqHvM/s640/P8240001.JPG


http://lh3.ggpht.com/_WhsyjpgLrx4/SpSNv063JuI/AAAAAAAAAbE/RVxeUgVpcOw/s640/P8240004.JPG


http://lh3.ggpht.com/_WhsyjpgLrx4/SpSNw8SnpSI/AAAAAAAAAbI/qC9Z2kHc_d0/s640/P8240008.JPG

[Mike Heidrick]

BTW - 6" is the LARGE Kreg clamp. 3" on the smaller one.

[Will Blick]

Great app Kevin, thanks