View Full Version : Repairing a disk sander....
Chuck Wintle
08-20-2009, 4:38 PM
I have an older Ryobi disk sander with the velcro to hold the sanding disk in place. the velcro wore out and was wondering how to repair this. Could i buy some velcro and glue it in place to make this work?
Jim Rimmer
08-20-2009, 4:42 PM
HD use to have some replacement pads. Haven't looked lateley but I had to do the same thing to mine once.
glenn bradley
08-20-2009, 5:03 PM
My HD had them just the other day. Not that I cruise the tool isle every time I'm there or anything ;-)
Bruce Wrenn
08-20-2009, 9:25 PM
Woodworkers Supply sells a H&L conversion kit, which will contain what you want.
David Christopher
08-20-2009, 9:34 PM
Charles, take out the screws from the pad ( where the sandpaper goes ) remove the pad go to the BORG and match up the screw holes and buy the one that fits.....they are about 6 bucks
Kyle Iwamoto
08-21-2009, 2:47 AM
Other brands fit? I been waiting to see a replacement one. I'll try that. Anyone else's must be good. The stock one sure is carp.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.