View Full Version : Need Easel Pattern
Cindy Rhoades
08-10-2009, 6:57 PM
I am looking for an easel pattern that I can run on my laser for marble and wooden plaques. I thought epilog had one in their sample club but I didn't see it there. If anyone could help I would greatly appreciate it.:confused:
Curt Stallings
08-10-2009, 9:50 PM
Here's one I got from here at the Creek. I'm sorry I don't remember who to credit.
Curt
Randy Walker
08-10-2009, 10:17 PM
Here are a couple of nice ones that I found here at the Creek (also don't remember who to credit).
Randy Walker
Cindy Rhoades
08-10-2009, 11:34 PM
Thank you both so very much I think these will work out wonderfully.
Ray Uebner
08-11-2009, 2:57 PM
Randy
Could you post for x3 and below. THanks
Roy Nicholson
08-12-2009, 6:51 AM
Regards
Roy N.
Mark Ross
08-12-2009, 9:08 AM
Must be the lack of enough coffee this morning, I am not able to visualize how any of these go together. Can I please request some pictures? Man...at work for over an hour and only have had time for 1/2 a cup of joe...
Ray Uebner
08-12-2009, 11:18 AM
Thank you for the post. They Look great good job. The other post I think was from Tom from Laserbuzz, at least that is where I got it from but your are a little more fancy and look nice, of course you really don't see the whole stand but could sell them too for people to put pictures on.
Randy Walker
08-13-2009, 10:42 AM
Sorry that is the first time that I have done an attatchment and I forgot to re-save so it could be used by more people. Ill give it another try now. Hope this helps.
Randy Walker
Still don't remember who I got it from, but thank you whoever you are.:)
Steve Middleton
11-15-2018, 10:11 AM
Thanks for this thread!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.