Need Easel Pattern

[Cindy Rhoades]

I am looking for an easel pattern that I can run on my laser for marble and wooden plaques. I thought epilog had one in their sample club but I didn't see it there. If anyone could help I would greatly appreciate it.:confused:

[Curt Stallings]

Here's one I got from here at the Creek. I'm sorry I don't remember who to credit.

Curt

[Randy Walker]

Here are a couple of nice ones that I found here at the Creek (also don't remember who to credit).
Randy Walker

[Cindy Rhoades]

Thank you both so very much I think these will work out wonderfully.

[Ray Uebner]

Randy
Could you post for x3 and below. THanks

[Roy Nicholson]

Regards

Roy N.

[Mark Ross]

Must be the lack of enough coffee this morning, I am not able to visualize how any of these go together. Can I please request some pictures? Man...at work for over an hour and only have had time for 1/2 a cup of joe...

[Ray Uebner]

Thank you for the post. They Look great good job. The other post I think was from Tom from Laserbuzz, at least that is where I got it from but your are a little more fancy and look nice, of course you really don't see the whole stand but could sell them too for people to put pictures on.

[Randy Walker]

Sorry that is the first time that I have done an attatchment and I forgot to re-save so it could be used by more people. Ill give it another try now. Hope this helps.

Randy Walker

Still don't remember who I got it from, but thank you whoever you are.:)

[Steve Middleton]

Thanks for this thread!