View Full Version : Mounting Hitachi C10FSH on a Bosch T4B?
Deck Reagan
07-22-2009, 10:20 AM
Hi everyone. I just bought the Hitachi C10FSH and the Bosch T4B stand. Has anyone used these two products together? It seems like I will need to mount the saw to a piece of ply and then to the T4B mounts is this correct?
Thanks,
deck
Rick Huelsbeck
07-22-2009, 10:45 AM
I put a 2x2 on either side of the saw and then ran screws into the 2x2 from under the T4B (Gravity Rise Stand)
Deck Reagan
07-22-2009, 12:37 PM
Rick,
You stand looks to have different mounts than mine, but I like your idea.
deck
Chris Tsutsui
07-22-2009, 1:42 PM
I attached my C10FSH to a new model Rigid M-SUV.
Square sheet of BB Plywood attached to the miter saw, and then the plywood bolted to the MSUV.
Works great
Chris Tsutsui
07-22-2009, 1:47 PM
BTW, I used the largest bolts possible and washer + lock washer.
I wouldn't trust using screws into the plywood to hold the saw... especially since i store it so the saw is vertical.
You may also consider lock nuts.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.