Beth Page
07-19-2009, 11:49 AM
I am wondering if I can vector cut with this material?
Its called Speedy-Stamp Carving Block, size is 4" x 6".
Joe Pelonio
07-19-2009, 12:07 PM
The manufacturer describes it as high density rubber, if that's true yes, it should cut safely. On the other hand, I cannot find any MSDS sheet for it, so there's no way to tell if it might contain unsafe elements such as PVC in the formulation. To be safe, I would suggest writing to the manufacturer to ask them if it's laser safe or at least whether it might contain any PVC.
Beth Page
07-21-2009, 9:54 PM
Thank you, and i will look into that.
Chris J Drew
07-22-2009, 5:07 AM
Or you could try the "burnination" test...
http://www.vimeo.com/1615418
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.