Jim Kappel
07-10-2009, 7:09 PM
I'm finally, after like 6 months, getting around to setting up my new Jet mortiser. One problem, I'm stuck on the chuck extension adaptor. I don't get how it is supposed to stay in place.
I got to this point....I got the chuck off, the adaptor is now stuck in the chuck (in the correct end), and now I'm trying to get the adaptor to stay put on the spindle...
The manual reads: "Push the optional chuck release nut to its former high position on the spindle" and then "Push the optional adaptor onto the spindle as shown. Then firmly push the chuck onto the adaptor."
There are no threads and it doesn't say anything about tightening the unit for it to stay. Any it's not staying!!!!
Any help?
Jim
I got to this point....I got the chuck off, the adaptor is now stuck in the chuck (in the correct end), and now I'm trying to get the adaptor to stay put on the spindle...
The manual reads: "Push the optional chuck release nut to its former high position on the spindle" and then "Push the optional adaptor onto the spindle as shown. Then firmly push the chuck onto the adaptor."
There are no threads and it doesn't say anything about tightening the unit for it to stay. Any it's not staying!!!!
Any help?
Jim