Best way to cut legs even?

[Brian Penning]

The photo says it all.
Looking for the best method to cut these stool legs so that they're all even and parallel to the floor.
TIA...

[Chris Friesen]

Scribe them relative to the workbench top, then cut to the line with a handsaw.

Alternately you could take a piece of wood the thickness of the amount you want to cut off, cut a hole in it so the leg can stick through, then just saw away with the saw resting on the spacer. This technique was discussed here in another thread, I think.

[Brian Kent]

Use the Vegas doubling system.

Cut one, double it on the next one, double that on the next, until you are flat on the floor.

[Joe Scharle]

Scribe them relative to the workbench top, then cut to the line with a handsaw.

Alternately you could take a piece of wood the thickness of the amount you want to cut off, cut a hole in it so the leg can stick through, then just saw away with the saw resting on the spacer. This technique was discussed here in another thread, I think.

And if you scribe all the way around the leg, you can check your cut as you saw.