Chris Harry
06-29-2009, 12:54 PM
Any recommendations on a bit set for an Incra LS setup?
I see different brands and some of them have different bit counts (6 pc, 8 pc, 11 pc, etc), so Im confused as to what a good kit would be to make at least MOST of the joints in the LS template library.
Any suggestions would be appreciated.
Thanks.
-Chris
I see different brands and some of them have different bit counts (6 pc, 8 pc, 11 pc, etc), so Im confused as to what a good kit would be to make at least MOST of the joints in the LS template library.
Any suggestions would be appreciated.
Thanks.
-Chris